Free Hydrogen Power

Free Hydrogen is not really free… and it is not really for everyone.

The Conspiracy Theorists might have a more darker thoughts about this statement. And the Naysayers… well, they will keep saying ney or nay.

At any rate, I am writing this blog merely for the purpose of sharing information to the worthy seekers, that’s you!

You probably think – there is someone out there who is actually sharing information for free!

Yes I am… and I do not intend to make this a long and uncomfortable read for you.

Don’t worry, I wont be telling you what HHO, Hydrogen, Oxygen, AF Ratios, Thermodynamics, Over Unity, AMPS Draw or anything of that sort here. You probably have bombarded yourself with information in other previous readings.

The question we want to address here is… “Can we actually make our own HHO system in our cars for free?”

Well, the answer is… perhaps it’s not entirely free… but you will be able to Do everything yourself!.

First things first; Materials…

We will be building a small HHO brick… small but strong. With a standard configuration of (+nn-nn+):

1. Stainless Steel 316 or 301 1mm thick plates (2″ x 3″ about 5 pieces) (Hand sanded, drilled with 6mm dia. holes on all 4 corners with about 10mm clearance on the edges.

2. Plastic Bolts and Nuts 4 pcs…. (6mm dia. threads 30mm in length or more) (plastic flat washers about 40 pcs. Plastic Nuts about 8 pcs.)

3. Stainless Steel wire eye terminals… (6.5mm inner diameter .5mm thk.) 3 pcs.

4. Stainless wires (if you can get one) (cut to length)

5. Stainless Steel Bolts and Nuts with flat washers and lock washers (6mm dia. 25mm) about 2 pcs. bolts and washers and 4 pcs. nuts.

6. HDPE Plastic Jar or Container… preferably cylindrical jar with threaded cap or lid. (about 4″ x 4″ x 8″) This will serve as your electrolyser container. (Drill 2 holes for the stainless bolts and 2 holes for the Brass fittings.
(1 Center hole for the HHO Gas output fitting… and one hole near the edge for the other breather inlet fitting. and the two smaller holes for the electrodes with equidistant locations… they need to be far apart but keep a clearance of about 15mm from the edges.

7. Brass Fittings (3/16″ or 1/4″) 2 pcs.

8. Fuel Hose… I recommend those black rubber hose or Vacuum hoses. (cut to length)

9. Automotive Wires with Eye Terminals (number 16, cut to length)

10. Fuse holder with fuse(15 AMPS, in line type)

11. For your bubbler, you may use the plastic (HDPE) reservoir similar to your radiator coolant reservoir.

As soon as you have the above materials in your table… the next step is to build your first Home-made HHO Generator – you can actually use right away!

Please stay tuned for the next article where I will be teaching you a step by step procedure on how you can build you first HHO – Hydrogen on demand module for your car.

Please be patient… and don’t blow things up just yet!

~ by ehnriko on July 16, 2008.